Our Services
Exhaust Work in Vantaa
Safe exhaust is essential for safety
Finnish salted winters can corrode exhaust systems before the engine reaches end of life — inspect at every MOT.
Exhaust repair pricing:
- Silencer replacement (mid or rear pipe) – from €211
- Exhaust manifold replacement – from €380
- Catalytic converter replacement – from €550
- Weld repair to leak – from €150
- Exhaust pipe rust protection – from €90
Our Services
Exhaust repair
Price includes parts and labour. The scope of the exhaust job is always assessed in advance so you get an accurate quote.
from150 €
When the exhaust needs renewing
In Finland exhaust system life is often shorter than vehicle life. Road salt corrodes the outside of the pipe and moisture condenses inside over short trips, causing rust to attack from both sides. A typical Finnish exhaust lasts 6–10 years — longer with plenty of motorway use, noticeably shorter with heavy short-trip city driving. The first symptom is often a deep, loud exhaust note that rises with acceleration. Small holes or leaks in silencer seams also increase exhaust drone. A worse problem is the pipe detaching from its rubber mount and scraping the ground — a metallic grating noise from underneath over humps and kerbs. At MOT the exhaust is measured with a decibel meter and the passing limit is 94 dB for passenger cars. A broken silencer or an internal hole easily exceeds this. Another common fail reason is an exhaust leak upstream of the cabin — that creates a gas poisoning risk for the driver.
Our Services
Why do exhausts corrode faster in Finland?
Exhaust corrosion typically starts from the inside out. On short trips condensate doesn't evaporate as the pipe heats up; it collects at the bottom of the silencer and rusts it from the inside. Motorway driving heats the pipe to 600 °C and the moisture burns off, but on city trips the pipe never reaches that temperature. The worst case is therefore short daily commuting where the pipe never fully warms. The other cause is road salt: winter salt attacks the protective paint on the outside and rust develops from outside in. Stainless steel is increasingly standard on modern cars, but for example the first silencer after the manifold still uses heat-resistant carbon steel, which corrodes more readily.
Other services
Related repair services
Technically adjacent repairs and maintenance for the same vehicle system.
Muffler Replacement
from 211 €
Replacing a rusty or damaged muffler. Reduces exhaust noise and meets MOT requirements.
DPF Replacement
from 720 €
Replacing or cleaning the diesel particulate filter (DPF). Clears fault codes and restores performance.
DPF Cleaning (Particulate Filter)
from 380 €
A mechanical DPF clean restores filter flow to near-new condition without the cost of replacing the part.
EGR Valve Replacement
from 520 €
Replacing or cleaning the EGR valve. Improves engine performance and reduces emissions.
EGR Valve Cleaning
from 280 €
Cleaning a dirty EGR valve. Improves engine performance and reduces emissions.
AdBlue Repair
from 180 €
AdBlue diagnostics, component replacement and software repairs. Restores drivability and passes the MOT.
Service overview
Exhaust Work in Vantaa starts with correct diagnosis and a clear work scope. Exhaust Work relates to engine cooling, sealing, combustion or mechanical durability. Correct diagnosis separates a worn part, leak and control fault.
What it does
Exhaust Work relates to engine cooling, sealing, combustion or mechanical durability. Correct diagnosis separates a worn part, leak and control fault.
Why it's critical
Correct scoping is critical because the same symptom can come from a worn part, electronic control, a leak or an earlier incomplete repair.
Why you shouldn't ignore it
Driving too long with the fault can damage related parts and turn a manageable service into a larger repair.
Commonly affected systems
- The exact part and equipment code is confirmed before ordering parts.
- Service history, driving pattern and symptom duration affect the repair route.
- The final scope is based on inspection.
Symptoms
Warning light or message
The car's own warning indicates that the system needs inspection before parts are replaced.
Changed driving feel
Vibration, hesitation, weak response or unusual behaviour helps locate the fault.
Unusual noise
Knocking, scraping, whining or squealing can indicate wear, play or incorrect load.
Leak, smell or visible damage
A fluid leak, burnt smell or torn protective boot should be checked promptly.
Symptom returns after reset
Clearing a fault code alone does not repair the mechanical or electrical root cause.
When is service needed?
Typical service interval
Need is assessed from symptoms, mileage and service history.
Factors that affect wear
Road salt, cold starts, short trips, load and previous repairs can accelerate wear.
Impact of maintenance and oil changes
Timely inspection reduces the risk of secondary damage.
Vehicle-specific checks
Engine and equipment details are checked for the specific car.
Risks of delaying
Fault spreads
A failed part can stress related components.
Repair cost rises
Continued driving can increase parts and labour.
The car may become unusable
Some faults progress quickly into limp mode or no-start.
Inspection may fail
A warning light, leak or safety-related fault can prevent approval.
Safety is reduced
Control of steering, braking, tyres or engine operation can change.
Our repair process
- 1
Symptom review
We review the customer's observations and decide what the inspection and repair requires before ordering parts.
- 2
Diagnosis and inspection
We check fault codes, live data and mechanical condition according to the job.
- 3
Repair plan
You receive an estimate for parts, labour time and price before work starts.
- 4
Repair work
The faulty part is replaced or serviced according to manufacturer guidance.
- 5
Road test and quality check
After repair we verify operation and road-test the car when needed.
Parts included in the repair
- Exhaust Work: Replaced with an engine-specific part.
- Gaskets: Seals in the work area are renewed.
- Fluids when needed: Oil or coolant is added as required by the job.
- Bolts and fasteners: Single-use bolts are renewed as specified.
- Pressure or leak test: Repair sealing is verified.
Repair time
Typical duration
Typical duration depends on scope: a small inspection can be quick, while a larger strip-down job can take a full working day or more.
Factors affecting completion time
Time is affected by parts availability, corrosion, fastener condition, programming and possible additional faults.
Vehicle availability after the repair
The car is returned only after operation has been checked. We tell you in advance if the job requires overnight stay.
Warranty
Warranty on labour
STG Autohuolto provides a 24-month warranty on labour.
Warranty on parts
Parts are covered by the warranty terms of the manufacturer or importer.
Warranty conditions
Warranty requires normal vehicle use and prompt inspection if follow-up symptoms appear.
What the warranty covers
Warranty covers defects in the work performed. It does not cover new faults, external damage or parts not replaced in this job.
Areas we serve
STG Autohuolto carries out exhaust work in Tuupakka, Vantaa. The location serves customers from Vantaa, Espoo and Helsinki, and booking can cover diagnosis, parts availability and repair timing in advance.
Expertise & trust
Brand experience
Exhaust Work is carried out according to the vehicle design, service history and manufacturer guidance, not just a generic job name.
Technical expertise
Experienced technicians identify whether the symptom comes from the part itself or from an electrical, mechanical or service-history related cause.
Professional diagnostics
We use fault codes, live data, mechanical inspection and road testing according to what the job requires.
Quality standards
Parts are selected from OE or OEM-quality options and the installation is checked before the car is returned.
Customer-focused service
You receive an estimate before work starts and an update if inspection reveals additional work or a more cost-effective repair route.
Frequently asked questions
How much does exhaust work cost?
Pricing usually starts from 150 €. The exact price depends on vehicle design, parts availability and whether inspection finds additional faults. Current pricing is available at /huoltohinnasto.
When should exhaust work be done?
Need is assessed from symptoms, mileage and service history.
Can I keep driving with the symptom?
Driving too long with the fault can damage related parts and turn a manageable service into a larger repair.
Which parts are usually replaced?
Typical items include: Exhaust Work, Gaskets, Fluids when needed, Bolts and fasteners. The final parts list is confirmed for the specific vehicle.
How long does the work take?
Typical duration depends on scope: a small inspection can be quick, while a larger strip-down job can take a full working day or more.
Is warranty included?
Yes. STG Autohuolto provides a 24-month warranty on labour, and parts are covered by the warranty terms of the manufacturer or importer.
Our Services
Can't Find the Service You Need?
We handle all car repair work. Request a free cost estimate by phone or by booking an appointment online.
Popular Services